Madison Radio Control Modelers

Frequency Use List...Who's flying on what channel?
Only one person can use a channel at one time !!!!!! (See Below)

This is the current chart of the allocated FCC frequencies in the 72 Mhz range for Aircraft use.

Ch #	User	Ch #	User	Ch #	User
11	Ted Nowell	28		45	Sammie Harris Gary Mills
12		29		46	Eddie Tuten
13		30	Ben Wertz	47	Steve Grubbs Sammie Harris Clay Tomlinson
14	Glen Peacock, Mike Norfleet	31	Sammie Harris	48	Ron Gunlach
15		32		49	Clay Tomlinson
16		33		50	Andy Tuten Gilbert Herndon
17	Sammy Harris	34	Gilbert Herndon	51
18		35		52
19		36	Steve Grubbs Justin Ledsome	53	Mike Norfleet
20	Lucas Waring	37	Pat Cantey	54	Ted Nowell
21		38		55
22	Gary Mills	39	Otto Ledsome	56	Glen Peacock
23	Ron Gunlach	40	Mike Norfleet	57	Johnny Lothridge
24		41		58	Bob Zacek
25	Gary Mills,	42	Gay Swift	59
26		43	John Lothridge	60	Alan Whigham
27		44	Rob Searcy Russell Spencer Bob Zacek

Only one person can use a channel at one time. If someone is using a channel and another person turns a transmitter on on the same channel, a crash is very likely to occur.

Flyers are to ALWAYS check to see that the channel they want to use is clear or not in use BEFORE turning on their transmitter.

The rule is: if you turn on your transmitter and cause a crash, you are responsible for replacing the total cost of the crashed aircraft.

We can share a channel by the use of a frequency board that has a clothespin on it for each channel. Check to see if the frequency pin is available before turning on your transmitter. To use your channel, remove the clothespin with your channel number on it and place the pin on your transmitter antenna. When you finish using the channel replace the pin to the frequency board.

When you see a pin missing from the frequency board, you know that channel is in use!